11381A
1.INSTALL REAR ENGINE OIL SEAL
Apply MP grease to the lip of a new rear engine oil seal.
Keep the lip free of foreign matter.
Do not allow MP grease to contact the dust seal.
| *1 | Rear Oil Seal Retainer |
| *2 | Rear Engine Oil Seal |
| *a | 0 to 1.0 mm (0 to 0.0394 in.) |
Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.
The acceptable depth from the top of the rear engine oil seal retainer is 0 to 1.0 mm (0 to 0.0394 in.)
Keep the lip free from foreign matter.
Do not tap the rear engine oil seal at an angle.
Make sure that the rear engine oil seal is properly installed.
11355
2.INSTALL REAR END PLATE
13405
3.INSTALL FLYWHEEL SUB-ASSEMBLY
31250
4.INSTALL CLUTCH DISC ASSEMBLY
31210
5.INSTALL CLUTCH COVER ASSEMBLY
31210
6.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY
33030
7.INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY