86101D
1.INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY
Attach the clamps and guide to install the No. 3 antenna cord sub-assembly.
Install the bolt and connect the connector.
86101J
2.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
Align the positioning tape of the No. 2 antenna cord sub-assembly with the protrusions of the roof headlining and wrap the positioning tape around them to install the positioning tape as shown in the illustration.
| *a | Positioning Tape | - | - |
|
Tape | - | - |
Install the No. 2 antenna cord sub-assembly with the tape aligned to each marking of the roof headlining assembly as shown in the illustration.
Secure the surplus of the No. 2 antenna cord sub-assembly at the <A> area of the illustration.
Secure the front part of the No. 2 antenna cord sub-assembly aligning the edge of the positioning tape and tab section of the roof headlining assembly.
Secure the rear part of the No. 2 antenna cord sub-assembly aligning the edge of the positioning tape and tab section of the roof headlining assembly.
63310
3.INSTALL ROOF HEADLINING ASSEMBLY
86101
4.INSTALL ANTENNA CORD SUB-ASSEMBLY
w/ Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
w/o Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
55302A
5.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.CHECK SRS WARNING LIGHT