A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
55303B
1.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Connect the hood lock control cable and fuel lid lock open cable.
Attach the guide and claw to connect the hood lock control lever sub-assembly and fuel lid lock open lever to the lower instrument panel sub-assembly.
Connect the connector.
Attach the guide to install the lower instrument panel sub-assembly.
Install the 7 screws <B>, 2 bolts <C> and screw <D>.
Attach the clamp and connect the illumination light.
| *a | Guide | *b | Screw <B> |
| *c | Bolt <C> | *d | Screw <D> |
| *e | Clamp | *f | Illumination Light |
55054
2.INSTALL GLOVE COMPARTMENT DOOR STOPPER SUB-ASSEMBLY
Attach the claw to install the glove compartment door stopper sub-assembly.
55550
3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Attach the hinge to install the glove compartment door assembly.
Attach the claw to connect the glove compartment door stopper sub-assembly.
|
Install in this Direction |
Install the glove door stopper pin and twist it as shown in the illustration.
Use the same procedure for both glove door stopper pins.
55607
4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
|
Install in this Direction |
Attach the guide.
Attach the claw to install the No. 2 instrument panel under cover sub-assembly as shown in the illustration.
73900
5.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55606
6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Attach the claw to connect the DLC3.
| *a | Screw <A> |
|
Install in this Direction |
Attach the guide and clip to install the No. 1 instrument panel under cover sub-assembly as shown in the illustration.
Install the 2 screws <A>.
55447C
7.INSTALL NO. 2 SWITCH HOLE BASE
for Automatic Air Conditioning System:
Connect the cooler thermistor connector and hose.
|
Install in this Direction |
Attach the clip to install the No. 2 switch hole base as shown in the illustration.
55407C
8.INSTALL LOWER INSTRUMENT COVER SUB-ASSEMBLY
|
Install in this Direction |
Connect the connector.
Attach the clip to install the lower instrument cover sub-assembly as shown in the illustration.
84013A
9.INSTALL INTEGRATION PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)
55905J
10.INSTALL CONTROL KNOB SUB-ASSEMBLY (for Manual Air Conditioning System)
55900
11.INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
86140A
12.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY (w/o Navigation System)
86120L
13.INSTALL NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)
84140
14.INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
58810J
15.INSTALL CONSOLE BOX ASSEMBLY
55302A
16.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
18.CHECK SRS WARNING LIGHT