The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the camshaft sub-assembly removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
51410
1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
2.DRAIN ENGINE COOLANT
3.DRAIN ENGINE OIL
16571C
4.REMOVE NO. 1 RADIATOR HOSE
16711
5.REMOVE FAN SHROUD
17113E
6.REMOVE NO. 1 INTAKE PIPE
17118
7.REMOVE MANIFOLD STAY
15301
8.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
23701
9.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
23704
10.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
23770
11.REMOVE NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
11201
12.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
23670
13.REMOVE INJECTOR ASSEMBLY
11322A
14.REMOVE NO. 1 TIMING BELT COVER
13568
15.REMOVE TIMING BELT
13505
16.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
13523P
17.REMOVE CAMSHAFT TIMING PULLEY
11322B
18.REMOVE NO. 2 TIMING BELT COVER
19.REMOVE CAMSHAFT SUB-ASSEMBLY
| *a | Key Groove |
| *b | Upward |
Turn the intake camshaft sub-assembly with a wrench so that the key groove of the intake camshaft sub-assembly faces upward.
Uniformly loosen the 15 camshaft bearing cap bolts in several passes in the sequence shown in the illustration.
Remove the 15 camshaft bearing cap bolts, No. 1 camshaft bearing cap, 3 No. 2 camshaft bearing caps, No. 3 camshaft bearing cap, camshaft oil seal and intake camshaft sub-assembly and exhaust camshaft sub-assembly from the cylinder head sub-assembly.