The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the crankshaft position sensor removal/installation are shown below.
1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
2.REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
for RC60/RC61:
Click hereDrivetrain>RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE>MANUAL TRANSMISSION ASSEMBLY>REMOVAL
31210
3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
31250
4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
13405
5.REMOVE FLYWHEEL SUB-ASSEMBLY
11355
6.REMOVE REAR END PLATE
12581A
7.REMOVE NO. 1 CYLINDER BLOCK INSULATOR
12585
8.REMOVE NO. 5 CYLINDER BLOCK INSULATOR
27148C
9.REMOVE CONNECTING WIRE
Disconnect the 2 connectors and clamp and remove the connecting wire.
10.REMOVE CRANKSHAFT POSITION SENSOR HARNESS BRACKET
Remove the bolt and crankshaft position sensor harness bracket from the cylinder block sub-assembly.
11401Q
11.REMOVE CRANKSHAFT POSITION SENSOR
Remove the bolt and crankshaft position sensor from the rear oil seal retainer.