Perform these procedures after the engine has cooled down.
1.INSPECT DRIVE BELT
Inspect the drive belt (See page Engine / Hybrid System>2TR-FE ENGINE MECHANICAL>DRIVE BELT>ON-VEHICLE INSPECTION).
2.REPLACE ENGINE OIL AND OIL FILTER
Replace the engine oil and oil filter (See page Engine / Hybrid System>2TR-FE LUBRICATION>OIL AND OIL FILTER>REPLACEMENT).
3.INSPECT COOLING AND HEATER SYSTEM
Check that the radiator, condenser and/or intercooler is not blocked with leaves, dirt or insects, and clean them if necessary. Also check the hose connection for the installation condition, corrosion, etc.
4.INSPECT ENGINE COOLANT
Inspect the engine coolant (See page Engine / Hybrid System>2TR-FE COOLING>COOLING SYSTEM>ON-VEHICLE INSPECTION).
5.REPLACE ENGINE COOLANT
Replace the engine coolant (See page Engine / Hybrid System>2TR-FE COOLING>COOLANT>REPLACEMENT).
6.INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
7.INSPECT SPARK PLUGS
Inspect the spark plugs (See page Engine / Hybrid System>2TR-FE ENGINE CONTROL>IGNITION SYSTEM>ON-VEHICLE INSPECTION).
8.REPLACE SPARK PLUGS
Replace the spark plugs (See page Engine / Hybrid System>2TR-FE ENGINE CONTROL>IGNITION COIL AND SPARK PLUG>REMOVAL).
9.INSPECT BATTERY ELECTROLYTE LEVEL
Inspect the battery electrolyte level (See page Power Source / Network>2TR-FE BATTERY / CHARGING>CHARGING SYSTEM>ON-VEHICLE INSPECTION).
10.REPLACE FUEL FILTER
Replace the fuel filter (See page Engine / Hybrid System>2TR-FE FUEL>FUEL FILTER>REPLACEMENT).
11.INSPECT AIR CLEANER FILTER
Remove the air cleaner filter.
Visually check that the air cleaner filter is not excessively damaged or oily. If necessary, replace the air cleaner filter with a new one.
If cleaning an air cleaner filter element, blow compressed air to clean it.
Reinstall the air cleaner filter.
12.INSPECT FUEL TANK CAP GASKET
Inspect the fuel tank cap gasket (See page Engine / Hybrid System>2TR-FE EMISSION CONTROL>FUEL TANK CAP>INSPECTION).
13.INSPECT FUEL LINES, FUEL LINE CONNECTIONS, FUEL TANK VAPOR VENT SYSTEM HOSES AND FUEL TANK BAND
Visually check the fuel lines and hoses for cracks, leakage, loose connections and deformation. Also, visually check the tank band for looseness.
14.INSPECT CHARCOAL CANISTER
Inspect the charcoal canister (See page Engine / Hybrid System>2TR-FE EMISSION CONTROL>CANISTER>INSPECTION).