1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
5.DISCONNECT NO. 1 FUEL HOSE
Disconnect the No. 1 fuel hose (See page Engine / Hybrid System>2TR-FE FUEL>FUEL SYSTEM>PRECAUTION).
6.DISCONNECT NO. 2 FUEL HOSE
Disconnect the No. 2 fuel hose.
7.REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY
8.REMOVE FUEL DELIVERY PIPE WITH FUEL INJECTOR
Disconnect the 4 wire harness clamps.
Disconnect the 4 injector connectors.
Disconnect the purge VSV connector.
Remove the vacuum hose.
Remove the 2 bolts and fuel delivery pipe together with the fuel injectors.
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.
Remove the 2 No. 1 delivery pipe spacers.
Remove the 4 injector vibration insulators.
Using a screwdriver, remove the 4 spacers.
Tape the screwdriver tip before use.
Remove the O-ring from the spacer.
9.REMOVE FUEL INJECTOR ASSEMBLY
|
Pull Out |
Remove the 4 fuel injectors from the fuel delivery pipe.