Home › Engine / Hybrid System › 2TR-FE INTAKE / EXHAUST › INTAKE MANIFOLD › 2011.07–2013.08
RM1880E _51 Engine / Hybrid System _013213 2TR-FE INTAKE / EXHAUST _0068488 INTAKE MANIFOLD A

2TR-FE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE STARTER ASSEMBLY

Hide 4.REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY (for Automatic Transmission)

Hide 5.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 6.REMOVE FRONT UPPER FENDER APRON SEAL

a.

Remove the 6 clips and front upper fender apron seal.


Hide 8.REMOVE INTAKE MANIFOLD

a.
A251798

Detach the 3 wire harness clamps from the 2 wire harness clamp brackets.


b.
A263012

Detach the No. 1 fuel hose from the intake manifold.


c.
A260162

for RHD:

Remove the bolt and disconnect the engine wire.


d.
A260163
0.063,0.063 0.385,0.406 0.323,0.344 10 *A 0.063,2.375 0.417,2.708 0.354,0.333 10 *B
*A for Automatic transmission
*B for Manual Transmission


Detach the No. 2 water by-pass hose.


e.

Disconnect the No. 3 PCV hose and vacuum hose from the intake manifold.


f.

for Automatic Transmission:

Remove the bolt and oil filler tube bracket.


g.
A252479

Remove the 5 bolts, 2 nuts and intake manifold.


h.

Remove the gasket from the intake manifold.


i.
A252480

Remove the 2 bolts and 2 wire harness clamp brackets from the intake manifold.


j.

Remove the purge line hose from the intake manifold.


Hide 9.REMOVE STUD BOLT

NOTICE:

If a stud bolt is deformed or its threads are damaged, replace it.


a.

Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.