Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT AXLE HUB INNER BEARING LH
Using SST and a press, press a new bearing into the steering knuckle.
Using snap ring pliers, install a new snap ring.
2.INSTALL FRONT AXLE HUB OIL SEAL LH
Using SST and a plastic-faced hammer, tap in a new oil seal.
Apply MP grease to the lip of the oil seal.
3.INSTALL STEERING KNUCKLE LH
Install the dust cover to the steering knuckle with the 3 bolts.
Using SST and a press, press the axle hub into the steering knuckle.
4.INSTALL FRONT SKID CONTROL ROTOR
Install the front skid control rotor.
5.INSTALL FRONT AXLE HUB NUT LH
Install a new nut to the axle hub.
Using a chisel and hammer, stake the nut.
Do not scratch the serration of the speed sensor rotor.
6.INSTALL KNUCKLE GREASE RETAINER CAP LH
Using a brass bar and hammer, install the knuckle grease retainer cap.
Do not damage the knuckle grease retainer cap.
7.INSTALL FRONT AXLE HUB ASSEMBLY
Install the front axle hub assembly.
8.CONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH
Connect the upper arm with the nut.
Install a new clip.
If the holes for the clip are not aligned, tighten the nut an additional 60°.
9.CONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH
Connect the suspension arm with the 2 bolts.
10.INSTALL TIE ROD END SUB-ASSEMBLY LH
Connect the tie rod end with the nut.
Install a new cotter pin.
If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.
11.INSTALL FRONT DISC
12.INSTALL FRONT SPEED SENSOR LH
Install the speed sensor with the bolt.
Connect the 3 clamps with the 3 bolts.
13.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Install the brake cylinder with the 2 bolts.
14.CONNECT FRONT FLEXIBLE HOSE
15.BLEED BRAKE LINE
16.INSTALL FRONT WHEEL
17.CHECK ABS SPEED SENSOR SIGNAL