Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.DRAIN BRAKE FLUID
3.REMOVE FRONT SPEED SENSOR LH
Remove the bolt and disconnect the speed sensor.
Remove the 3 bolts and disconnect the 3 clamps.
4.DISCONNECT FRONT FLEXIBLE HOSE
5.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH
Remove the union bolt and gasket, and disconnect the brake hose from the brake cylinder.
Remove the 2 bolts and brake cylinder.
6.REMOVE FRONT DISC
7.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
8.DISCONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH
Remove the 2 bolts and disconnect the lower suspension arm from the steering knuckle.
9.DISCONNECT FRONT UPPER SUSPENSION ARM ASSEMBLY LH
Support the front axle hub assembly with a jack.
Remove the clip and nut.
Using SST, disconnect the steering knuckle from the upper suspension arm.
10.REMOVE FRONT AXLE HUB ASSEMBLY
11.REMOVE KNUCKLE GREASE RETAINER CAP LH
Using a screwdriver and hammer, tap out the knuckle grease retainer cap.
12.REMOVE FRONT AXLE HUB NUT LH
Using a chisel and hammer, loosen the staked part of the hub nut.
Remove the hub nut.
13.REMOVE FRONT SKID CONTROL ROTOR
Remove the front skid control rotor.
Take care not to scratch the serration of the speed sensor rotor.
14.REMOVE STEERING KNUCKLE LH
Remove the 3 bolts, and shift the dust cover towards the hub (outside).
Using SST, remove the steering knuckle.
Remove the dust cover from the axle hub.
Take care not to scratch the serration of the speed sensor rotor.
15.REMOVE FRONT AXLE HUB OIL SEAL LH
Using a screwdriver, pry out the oil seal from the steering knuckle.
16.REMOVE FRONT AXLE HUB INNER BEARING LH
Using snap ring pliers, remove the snap ring.
Using SST and a press, press out the bearing from the steering knuckle.