Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE SHAFT
RM1880E _52 Drivetrain _013221 AXLE AND DIFFERENTIAL _0068540 REAR AXLE SHAFT A

AXLE AND DIFFERENTIAL  REAR AXLE SHAFT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR AXLE SHAFT OIL SEAL LH

F050080
1.75,0.844 2.313,0.531 false 2.375,0.406 2.875,0.708 0.5,0.302 10 false SST

a.

Coat the lip of a new oil seal with MP grease.


b.

Using SST, tap in the oil seal.

SST
09517-30010  


Hide 2.INSTALL REAR AXLE SHAFT ASSEMBLY

F052429

a.

Install the gasket to the axle housing with the cutout portion facing downward.


b.

Connect the rear brake to the rear axle housing.


c.

Align the hole of the gasket with the protrusion of the retainer and install the gasket.


d.
F050072
1.917,1.281 2.521,0.854 false 2.583,0.729 3.052,1.01 0.469,0.281 10 false SST

Using SST, tap in the axle shaft.

SST
09520-00031  

NOTICE:

Be careful not to damage the oil seal.



e.

Face the protrusion of the outer retainer downward.


f.

Install the outer retainer mounting with the 4 nuts.

Torque:
80 N*m (816 kgf*cm, 59 in.*lbf)


Hide 3.CONNECT BRAKE LINE

a.

Using a union nut wrench, connect the brake line to the wheel cylinder.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page Brake>BRAKE (REAR)>REAR BRAKE>INSTALLATION).



Hide 5.INSTALL BRAKE DRUM

Hide 6.BLEED BRAKE LINE

Hide 7.INSTALL REAR WHEEL

Torque:
110 N*m (1122 kgf*cm, 81 ft.*lbf)

Hide 8.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL