1.CHECK PARKING BRAKE LEVER TRAVEL
Pull the parking brake lever to fully engage the parking brake.
Release the lever to disengage the parking brake.
Slowly pull the parking brake lever all the way, and count the number of clicks.
6 to 9 clicks
2.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
3.REMOVE REAR WHEEL
4.ADJUST BRAKE SHOE CLEARANCE
5.ADJUST PARKING BRAKE LEVER TRAVEL
Completely release the parking brake lever.
| *1 | Lock Nut |
| *2 | No. 1 Parking Brake Cable Adjusting Nut |
Loosen the lock nut.
Turn the No. 1 parking brake cable adjusting nut until the lever travel is correct.
Tighten the lock nut.
If the lever travel cannot be fully adjusted with this procedure, proceed to the Adjust Parking Brake Turn Buckle procedure.
6.ADJUST PARKING BRAKE TURN BUCKLE
| *1 | Lock Nut |
| *2 | Turn Buckle |
Loosen the lock nut and turn the buckle until the lever travel is correct.
Tighten the lock nut.
7.INSPECT BRAKE WARNING LIGHT
Operate the parking brake lever and check the illumination condition of the brake warning light.
The brake warning light always illuminates at the first click.
8.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
9.INSTALL REAR WHEEL