Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM1880E _53 Suspension _013224 REAR SUSPENSION _0068553 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 4.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 5.DISCONNECT REAR BRAKE TUBE FLEXIBLE HOSE

C281519
1.021,0.604 1.354,0.604 1.354,0.604 1.625,0.99 false 2.125,2.896 1.604,2.26 1.604,2.26 2.271,2.021 false 1.406,2.146 1.802,2.417 0.396,0.271 10 false *1 0.813,0.49 1.177,0.74 0.365,0.25 10 false *a
*1 Flexible Hose
*a Brake Line


a.

Using a union nut wrench, disconnect the brake line from the flexible hose.


b.

Using a screwdriver, remove the clip.

HINT:

Tape the screwdriver tip before use.



c.

Remove the flexible hose from the 3 way joint.


Hide 6.DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH

Hide 7.REMOVE REAR COIL SPRING

a.

Slowly lower the rear axle housing.

NOTICE:

Be careful not to snap the brake line or parking brake cable.



b.

While lowering the axle housing, remove the coil spring and insulator.