Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER
RM1880E _54 Brake _013227 BRAKE SYSTEM (OTHER) _0068567 BRAKE BOOSTER A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.

HINT:

Tighten the lock nut after adjusting the brake pedal height.



b.

Install a new brake booster gasket to the brake booster.


c.

Install the booster with the 4 nuts.

Torque:
14 N*m (145 kgf*cm, 10 ft.*lbf)


d.

Install the push rod clevis to the brake booster.


e.

Apply a light coat of lithium soap base glycol grease to the clevis pin.


f.
C226773C27
1.031,2.417 1.031,2.208 1.031,2.208 0.771,2.208 false 1.948,1.208 1.302,0.802 1.302,0.802 1.177,0.802 false 2.177,1.99 2.177,2.781 2.177,2.781 2.281,2.781 true 0.99,0.719 1.271,0.99 0.281,0.271 10 false *1 0.594,2.125 0.844,2.396 0.25,0.271 10 false *3 2.333,2.708 2.594,3.01 0.26,0.302 10 false *2
*1 Brake Pedal Return Spring
*2 Clevis Pin
*3 Clip


Install the clevis pin and a new clip.

NOTICE:

The clip must be installed as shown in the illustration.



g.

Install the return spring.


h.

Install a new grommet and vacuum check valve to the booster.


i.

Connect the vacuum hose.


Hide 2.CHECK AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 3.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 5.BLEED AIR FROM CLUTCH LINE (for Manual Transmission)

Hide 6.CHECK AND ADJUST BRAKE PEDAL HEIGHT