Home › Brake › PARKING BRAKE › PARKING BRAKE LEVER
RM1880E _54 Brake _013230 PARKING BRAKE _0068574 PARKING BRAKE LEVER A

PARKING BRAKE  PARKING BRAKE LEVER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY

a.
C237685

Install the parking brake switch to the lever with the screw.


b.

Connect the parking brake switch connector.


c.
C237674

Connect the cable to the lever with the 2 bolts and 2 nuts.

Torque:
15 N*m (148 kgf*cm, 11 ft.*lbf)


d.
C237679
0.76,2.688 0.49,2.688 0.49,2.688 0.49,2.823 false 0.417,2.844 0.688,3.031 0.271,0.188 10 false *1
*1 Claw


Return the claw to its original position.


e.
C237673

Install the lever with the 2 bolts.

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)


f.
C237675
1.563,0.969 0.479,0.969 true 1.521,1.125 0.865,1.646 0.865,1.646 0.5,1.646 true 0.313,0.885 0.458,1.042 0.146,0.156 10 false *1 0.333,1.552 0.479,1.708 0.146,0.156 10 false *2
*1 Lock Nut
*2 No. 1 Parking Brake Cable Adjusting Nut


Install the No. 1 parking brake cable adjusting nut and lock nut.

Torque:
5.2 N*m (53 kgf*cm, 46 in.*lbf)


Hide 2.ADJUST PARKING BRAKE

Hide 3.INSTALL PARKING BRAKE LEVER COVER

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).