Home › Steering › STEERING COLUMN › STEERING WHEEL
RM1880E _55 Steering _013232 STEERING COLUMN _0068580 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


PROCEDURE

Hide 2.INSTALL STEERING WHEEL ASSEMBLY

a.

Align the matchmarks on the steering wheel assembly and steering main shaft.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 3.INSTALL NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

a.

Attach the 2 pins and install the steering wheel ornament.


b.

Install the screw.


Hide 4.INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)

a.

Attach the 2 pins and install the steering wheel ornament.


b.

Install the screw.


Hide 5.INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)

Hide 7.INSPECT STEERING WHEEL CENTER POINT

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).