Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM1880E _58 Vehicle Interior _013242 SUPPLEMENTAL RESTRAINT SYSTEMS _0068637 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

a.

Attach the 3 claws to install the spiral cable sub-assembly.

NOTICE:

When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.


HINT:

When installing a new spiral cable make sure to remove the stopper.



b.

Connect the connectors.

NOTICE:

When handling the airbag connector, do not damage the airbag wire harness.



Hide 4.ADJUST SPIRAL CABLE SUB-ASSEMBLY (REUSE ONLY)

a.

Turn the ignition switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B277382

Rotate the spiral cable sub-assembly with steering sensor counterclockwise slowly by hand until it feels firm.

NOTICE:

Do not use the airbag wire harness to turn the spiral cable sub-assembly.



d.
B278684
3.063,0.667 2.917,0.667 false 2.917,0.667 2.604,1.25 true 2.917,0.667 2.625,1.458 true 3.073,0.573 3.229,0.75 0.156,0.177 10 false *a
*a Mark


Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to align the marks.

NOTICE:

Do not turn the spiral cable with steering sensor by the airbag wire harness.


HINT:

The spiral cable with steering sensor can be rotated approximately 2.5 turns to both the left and right from the center position.



Hide 5.INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 6.INSTALL STEERING WHEEL ASSEMBLY