1.INSTALL WITH HOLDER ANTENNA ASSEMBLY
Install the antenna as shown in the illustration.
Stow the antenna pole before installing the antenna.
Install the 2 screws.
Connect the connector.
2.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
4.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).