Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068588 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  INSTALLATION  


PROCEDURE

Hide 1.INSTALL ANTENNA CORD SUB-ASSEMBLY

a.

Attach the 4 clamps shown in the illustration to install the antenna cord.

E226371


b.

Connect the connector.


Hide 2.INSTALL ANTENNA CORD SUB-ASSEMBLY (for Glass Antenna Type)

a.

Install the antenna cord with the clamp bolt.

E226372


b.

Attach the 5 clamps.


c.

Connect the connector.


Hide 3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).