Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM1880E _56 Audio / Visual / Telematics _013234 AUDIO / VIDEO _0068594 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

Microphone signal from the telephone microphone assembly is sent to the radio and display receiver assembly.

Also, power is supplied from the radio and display receiver assembly to the telephone microphone assembly.

If microphone signal is disconnected, this DTC is stored.

This DTC is stored when a malfunction occurs in a connected device.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Telephone microphone signal is lost.
·

Map light assembly (telephone microphone assembly)

·

Radio and display receiver assembly



WIRING DIAGRAM

C240174
1.344,1.854 1.49,2.052 0.146,0.198 10 false 2 1.333,1.26 1.51,1.448 0.177,0.188 10 false 3 1.333,0.656 1.51,0.833 0.177,0.177 10 false 4 5.792,3.031 5.969,3.208 0.177,0.177 10 false 6 0.865,1.927 1.313,2.115 0.448,0.188 10 false MCO- 0.833,1.344 1.302,1.521 0.469,0.177 10 false MCO+ 0.833,0.75 1.344,0.948 0.51,0.198 10 false MACC 5.958,3.135 6.406,3.323 0.448,0.188 10 false SNS2 5.74,2.448 5.979,2.656 0.24,0.208 10 false 18 2.635,2.656 3.292,2.875 0.656,0.219 10 false Shielded 3.979,2.656 4.615,2.885 0.635,0.229 10 false Shielded 5.958,2.521 6.406,2.719 0.448,0.198 10 false SGND 5.74,1.854 5.979,2.052 0.24,0.198 10 false 19 5.969,1.938 6.344,2.146 0.375,0.208 10 false MIN- 5.792,1.26 6,1.469 0.208,0.208 10 false 5 5.958,1.333 6.354,1.583 0.396,0.25 10 false MIN+ 5.792,0.677 5.969,0.896 0.177,0.219 10 false 4 0.302,3.563 0.531,3.771 0.229,0.208 10 false N5 0.302,3.74 2.292,4.271 1.99,0.531 10 false Map Light Assembly (Telephone Microphone Assembly) 5.719,3.563 6.156,3.771 0.438,0.208 10 false G127 5.958,0.74 6.458,0.969 0.5,0.229 10 false MACC 5.729,3.74 6.927,4.219 1.198,0.479 10 false Radio and Display Receiver Assembly

CAUTION / NOTICE / HINT

HINT:

For vehicles equipped with an Extension Module, refer to optional equipment's manuals.


PROCEDURE

1.CHECK MICROPHONE (OPERATION CHECK)
E222013


b.

When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

OK:

Check result is normal.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER - MAP LIGHT)
a.

Disconnect the G127 radio and display receiver assembly connector.


b.

Disconnect the N5 map light assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-4 (MACC) - N5-4 (MACC) Always Below 1 Ω
G127-5 (MIN+) - N5-3 (MCO+)
G127-19 (MIN-) - N5-2 (MCO-)
G127-6 (SNS2) - Body ground
G127-4 (MACC) - Body ground Always 10 kΩ or higher
G127-5 (MIN+) - Body ground
G127-19 (MIN-) - Body ground
G127-18 (SGND) - Body ground



Result:
Proceed to
OK
NG



OK

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
E199613
1.458,0.302 1.865,0.542 0.406,0.24 2.042,1.333 1.552,0.708 1.552,0.708 1.448,0.708 true 2.198,1.188 2.396,0.49 2.396,0.49 2.51,0.49 true 2.198,1.438 2.344,1.875 2.344,1.875 2.438,1.875 true 0.115,0.052 0.427,0.208 0.313,0.156 10 *a 1.5,0.344 1.906,0.563 0.406,0.219 10 G127 1.125,0.615 1.531,0.833 0.406,0.219 10 MIN- 2.552,0.417 3.083,0.698 0.531,0.281 10 MACC 2.479,1.802 3.01,2.083 0.531,0.281 10 SGND
*a Component with harness connected
(Radio and Display Receiver Assembly)


a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G127-18 (SGND) - Body ground Always Below 1 Ω
G127-19 (MIN-) - Body ground



b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
G127-4 (MACC) - Body ground Ignition switch ACC 4 to 6 V



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

4.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
a.

Replace the telephone microphone with a normal one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>TELEPHONE MICROPHONE>REMOVAL


b.

Check if the same problem occurs again.

OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)

NG

REPLACE MAP LIGHT ASSEMBLY