Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING BUZZER
RM1880E _56 Audio / Visual / Telematics _013235 PARK ASSIST / MONITORING _0068595 CLEARANCE WARNING BUZZER A

PARK ASSIST / MONITORING  CLEARANCE WARNING BUZZER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 CLEARANCE WARNING BUZZER

a.

Attach the clamp to install the No. 1 clearance warning buzzer.


b.

Connect the connector.


Hide 2.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

a.

Install the upper instrument panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION).


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 4.CHECK SRS WARNING LIGHT