Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL NO. 1 HEATER RELAY
Install the No. 1 heater relay.
Attach the 2 clamps to install the driver side junction block.
Install the 2 nuts.
2.INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).