Home › Vehicle Interior › HEATING / AIR CONDITIONING › RELAY(for Heater)
RM1880E _58 Vehicle Interior _013245 HEATING / AIR CONDITIONING _0068684 RELAY(for Heater) A

HEATING / AIR CONDITIONING  RELAY(for Heater)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 4.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 5.REMOVE NO. 1 HEATER RELAY

E235159

a.

Remove the 2 nuts.


b.

Detach the 2 clamps and disconnect the driver side junction block.


c.
E231910

Remove the No. 1 heater relay.