Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for Automatic Cooler System)
RM1880E _59 Vehicle Exterior _013248 WINDOW / GLASS _0068696 WINDOW DEFOGGER SWITCH(for Automatic Cooler System) A

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for Automatic Cooler System)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL NO. 1 COOLER WIRE

a.
B280828
0.552,1 0.281,1 true 2.646,0.333 2.521,0.333 false 2.646,1.417 2.531,1.417 false 0.073,0.906 0.333,1.135 0.26,0.229 10 false *1 2.333,0.229 2.552,0.469 0.219,0.24 10 false *2 2.365,1.313 2.646,1.594 0.281,0.281 10 false *2
*1 Air Conditioning Amplifier Assembly
*2 No. 1 Cooler Wire


Install the No. 1 cooler wire to the air conditioning amplifier assembly as shown in the illustration.


Hide 3.CONNECT NO. 1 COOLER WIRE

a.
B280829

Connect the connector as shown in the illustration.


Hide 5.INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 6.INSTALL CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).