Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SWITCH(for Automatic Cooler System)
RM1880E _59 Vehicle Exterior _013248 WINDOW / GLASS _0068696 WINDOW DEFOGGER SWITCH(for Automatic Cooler System) A

WINDOW / GLASS  WINDOW DEFOGGER SWITCH(for Automatic Cooler System)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL

Hide 4.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 6.DISCONNECT NO. 1 COOLER WIRE.

a.
B280826

Disconnect the No. 1 cooler wire from the air conditioning amplifier assembly as shown in the illustration.


Hide 8.REMOVE NO. 1 COOLER WIRE

a.
B280827
0.552,1 0.281,1 true 2.656,0.323 2.531,0.323 false 2.656,1.344 2.542,1.344 false 0.073,0.896 0.385,1.156 0.313,0.26 10 false *1 2.354,0.219 2.615,0.469 0.26,0.25 10 false *2 2.344,1.24 2.563,1.479 0.219,0.24 10 false *2
*1 Air Conditioning Amplifier Assembly
*2 No. 1 Cooler Wire


Remove the No. 1 cooler wire from the air conditioning amplifier assembly as shown in the illustration.