Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
6.REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (w/ Front No. 2 Speaker)
7.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
8.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH
9.REMOVE FRONT DOOR NO. 1 TRIM BRACKET
10.REMOVE FRONT DOOR SERVICE HOLE COVER LH
11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
12.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH
13.REMOVE FRONT DOOR GLASS RUN LH
14.REMOVE FRONT DOOR UPPER OUTER BLACK OUT TAPE LH
When removing the front door upper outer black out tape, heat the front door panel and front door upper outer black out tape using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Front Door Upper Outer Black Out Tape | 40 to 60°C (104 to 140°F) |
Do not heat the front door panel or front door upper outer black out tape excessively.
Pull back an edge of the front door upper outer black out tape and pull it parallel to the front door panel to remove it.
15.REMOVE FRONT DOOR REAR OUTER BLACK OUT TAPE LH
When removing the front door rear outer black out tape, heat the front door panel and front door rear outer black out tape using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| Front Door Rear Outer Black Out Tape | 40 to 60°C (104 to 140°F) |
Do not heat the front door panel or front door rear outer black out tape excessively.
Pull back an edge of the front door rear outer black out tape and pull it parallel to the front door panel to remove it.