Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE(for Rear Door)
RM1880E _59 Vehicle Exterior _013254 EXTERIOR PANELS / TRIM _0068764 BLACK OUT TAPE(for Rear Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 4.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 5.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

Hide 6.REMOVE REAR DOOR NO. 2 TRIM BRACKET

Hide 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

Hide 9.REMOVE REAR DOOR GLASS RUN LH

Hide 10.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 12.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

Hide 13.REMOVE FRONT OUTER BLACK OUT TAPE LH

HINT:

When removing the front outer black out tape, heat the rear door panel and front outer black out tape using a heat light.


Standard:
Item Temperature
Rear Door Panel 40 to 60°C (104 to 140°F)
Front Outer Black Out Tape 40 to 60°C (104 to 140°F)


NOTICE:

Do not heat the rear door panel or front outer black out tape excessively.


a.
B282270

Pull back an edge of the front outer black out tape and pull it parallel to the rear door panel to remove it.


Hide 14.REMOVE UPPER OUTER BLACK OUT TAPE LH

HINT:

When removing the upper outer black out tape, heat the rear door panel and upper outer black out tape using a heat light.


Standard:
Item Temperature
Rear Door Panel 40 to 60°C (104 to 140°F)
Upper Outer Black Out Tape 40 to 60°C (104 to 140°F)


NOTICE:

Do not heat the rear door panel or upper outer black out tape excessively.


a.
B282271

Pull back an edge of the upper outer black out tape and pull it parallel to the rear door panel to remove it.


Hide 15.REMOVE REAR OUTER BLACK OUT TAPE LH

HINT:

When removing the rear outer black out tape, heat the rear door panel and rear outer black out tape using a heat light.


Standard:
Item Temperature
Rear Door Panel 40 to 60°C (104 to 140°F)
Rear Outer Black Out Tape 40 to 60°C (104 to 140°F)


NOTICE:

Do not heat the rear door panel or rear outer black out tape excessively.


a.
B282272

Pull back an edge of the rear outer black out tape and pull it parallel to the rear door panel to remove it.