2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Headlight Cleaner Switch Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit detects the conditions (on or off) of the headlight cleaner switch assembly.

WIRING DIAGRAM

B246538E01

INSPECTION PROCEDURE


1. INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY
E204130
  1. Remove the headlight cleaner switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 - 8
    Headlight cleaner switch on
    Below 1 Ω
    5 - 8
    Headlight cleaner switch off
    10 kΩ or higher



NG
REPLACE HEADLIGHT CLEANER SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY AND MAIN BODY ECU)
  1. Disconnect the G72 headlight cleaner switch connector.

  1. Disconnect the A38 headlight cleaner control relay connector.

  1. Remove the main body ECU (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G72-8 - A38-2
    Always
    Below 1 Ω
    G72-5 - A-15 (HRLY)
    Always
    Below 1 Ω
    G72-8 - Body ground
    Always
    10 kΩ or higher
    G72-5 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (MAIN BODY ECU - HEADLIGHT CLEANER CONTROL RELAY)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Rear Wiper does not Operate (from Aug 2014)Headlight Cleaner Switch Circuit (from Aug 2014) →