Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM
Engine Hood Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The security courtesy switch is built into the hood lock. This switch turns on when the engine hood is opened and turns off when the engine hood is closed.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. READ VALUE USING INTELLIGENT TESTER (SECURITY COURTESY SWITCH)
Using the intelligent tester, read the Data List (Click here ).
Main Body
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Hood Courtesy SW
Security courtesy switch / ON or OFF
ON: Engine hood open OFF: Engine hood closed
-
OK:
ON (engine hood open) and OFF (engine hood closed) appear on screen according to condition of engine hood.
NG
OK
2. INSPECT SECURITY COURTESY SWITCH
Disconnect the A27 switch connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
2 - 3
Always
Below 1 Ω
NG
OK
3. CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - MAIN BODY ECU AND BODY GROUND)
Disconnect the A27 switch connector.
Disconnect the G64 ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
A27-2 - G64-12 (HD2)
Always
Below 1 Ω
A27-3 - Body ground
Always
Below 1 Ω
A27-2 or G64-12 (HD2) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )
4. INSPECT SECURITY COURTESY SWITCH
Disconnect the A27 switch connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 4
Unlock position
Below 1 Ω
1 - 4
Lock position
10 kΩ or higher
NG
OK
5. CHECK HARNESS AND CONNECTOR (SECURITY COURTESY SWITCH - MAIN BODY ECU AND BODY GROUND)
Disconnect the A27 switch connector.
Remove the main body ECU (Click here ).
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
A27-1 - A-20 (HCTY)
Always
Below 1 Ω
A27-4 - Body ground
Always
Below 1 Ω
A27-1 or A-20 (HCTY) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here )