Security Indicator Light Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
- When the theft deterrent system is in the disarmed state, the security indicator light flashes continuously when the engine immobiliser system is set, and does not illuminate when the engine immobiliser system is not set.
When the theft deterrent system is in the armed state, the engine immobiliser system is automatically set and the security indicator light flashes continuously.
When the theft deterrent system is in the arming preparation state or alarm sounding state, the main body ECU causes the security indicator light to be illuminated.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT) |
Operate the intelligent tester according to the steps on the display and select Active Test (Click here).
Main Body Tester Display
Test Part
Control Range
Diagnostic Note
Security Indicator
Security indicator light
ON/OFF
The test is possible when the following conditions are met: - The key is in the cabin*1
- The engine switch on (IG)*1
- The key is in the ignition key cylinder*2
- *1: w/ Entry and Start System
- *2: w/o Entry and Start System
- OK:
- Security indicator light can be turned on and off using the intelligent tester.
- The key is in the cabin*1
|
|
||||
| OK | ||
| ||
| 2. INSPECT SECURITY INDICATOR LIGHT ASSEMBLY |
Remove the security indicator light (Click here).

Apply battery voltage between the terminals of the security indicator light assembly and check that the security indicator light illuminates.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → 2 (LP)
Battery negative (-) → 5 (E)
Security indicator light illuminates
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - MAIN BODY ECU AND BODY GROUND) |
Disconnect the H23 light connector.
Remove the main body ECU (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H23-2 (LP) - A-23 (IND)
Always
Below 1 Ω
H23-5 (E) - Body ground
Always
Below 1 Ω
H23-2 (LP) or A-23 (IND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
