2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When the theft deterrent system is in the disarmed state, the security indicator light flashes continuously when the engine immobiliser system is set, and does not illuminate when the engine immobiliser system is not set.
    When the theft deterrent system is in the armed state, the engine immobiliser system is automatically set and the security indicator light flashes continuously.
    When the theft deterrent system is in the arming preparation state or alarm sounding state, the main body ECU causes the security indicator light to be illuminated.

WIRING DIAGRAM

B236698E03

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
  1. Operate the intelligent tester according to the steps on the display and select Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    The test is possible when the following conditions are met:
    1. The key is in the cabin*1
    2. The engine switch on (IG)*1
    3. The key is in the ignition key cylinder*2
    1. *1: w/ Entry and Start System
    2. *2: w/o Entry and Start System

    OK:
    Security indicator light can be turned on and off using the intelligent tester.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT SECURITY INDICATOR LIGHT ASSEMBLY

  1. B238374E01
    Remove the security indicator light (Click here).

  1. Apply battery voltage between the terminals of the security indicator light assembly and check that the security indicator light illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 2 (LP)
    Battery negative (-) → 5 (E)
    Security indicator light illuminates



NG
REPLACE SECURITY INDICATOR LIGHT ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the H23 light connector.

  1. Remove the main body ECU (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H23-2 (LP) - A-23 (IND)
    Always
    Below 1 Ω
    H23-5 (E) - Body ground
    Always
    Below 1 Ω
    H23-2 (LP) or A-23 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Theft Warning Siren Circuit (from Aug 2014)Security Indicator Light Circuit (from Aug 2014) →