ABS Warning Light does not Come ON
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN communication.WIRING DIAGRAM
Refer to ABS Warning Light Remains ON (Click here).INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).
Result Result
Proceed to
DTC not output
A
DTC output
for LHD without Entry and Start System
B
DTC output
for RHD without Entry and Start System
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK ABS WARNING LIGHT |
Disconnect the skid control ECU connector.
Turn the ignition switch to ON.
Check that the ABS warning light comes on.
- OK:
- The ABS warning light comes on.
|
|
||||
| OK | ||
| ||
| 3. READ VALUE USING INTELLIGENT TESTER (ABS WARNING LIGHT) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| ABS Warning Light |
ABS warning light / ON or OFF |
OFF |
- |
When performing the ABS Warning Light Active Test, check ABS Warning Light in the Data List (Click here).
| Tester Display |
Test Part |
Control Range |
Diagnostic Note |
| ABS Warning Light |
ABS warning light |
Warning light ON/OFF |
Observe the combination meter. |
| Result |
Proceed to |
|
| Data List Display |
Data List Display when Performing Active Test ON/OFF Operation |
|
| ON |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
| OFF |
Does not change between ON and OFF |
A |
| Changes between ON and OFF |
B |
|
|
|
||||
| A | ||
| ||
