2013-2015 Land Cruiser Prado · Service Manual Brake

VSC Buzzer Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.
The combination meter assembly has a built-in buzzer.

WIRING DIAGRAM

C230884E11

INSPECTION PROCEDURE

NOTICE:
When replacing the skid control ECU (brake actuator assembly), perform calibration (Click here).


1. CHECK CAN COMMUNICATION LINE
  1. Check if CAN communication system DTCs are output (for LHD without Entry and Start System: Click here, for RHD without Entry and Start System: Click here).

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    for LHD without Entry and Start System
    B
    DTC output
    for RHD without Entry and Start System
    C



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. READ VALUE USING INTELLIGENT TESTER (BUZZER)
  1. Turn the engine switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.

ABS/VSC/TRAC 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Buzzer
Buzzer/ ON or OFF
ON: Buzzer on
OFF: Buzzer off
The combination meter has a built-in buzzer.
  1. When performing the Buzzer Active Test, check Buzzer in the Data List (Click here).

ABS/VSC/TRAC 
Tester Display
Test Part
Control Range
Diagnostic Note
Buzzer
Buzzer
Buzzer ON/OFF
The buzzer can be heard.
Result 
Result
Proceed to
Data List Display
Data List Display when Performing Active Test ON/OFF Operation
ON
Changes between ON and OFF
A
Does not change between ON and OFF
B
OFF
Changes between ON and OFF
A
Does not change between ON and OFF
B


B
Go to step 3
A

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

3. INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← VSC Buzzer Circuit (Aug 2013 – Jul 2014)TC and CG Terminal Circuit (Aug 2013 – Jul 2014) →