DTC CHECK / CLEAR
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| CHECK DTC (USING GTS) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs.
| CHECK DTC (USING SST CHECK WIRE) |
![]() ![]() |
Turn the ignition switch off.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
- SST
- 09843-18040
Turn the ignition switch ON.
Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration for examples of a normal system code and codes 13 and 33.
- HINT:
- If the tire pressure warning light does not indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC and CG terminal circuit.
Trouble Area
See page
Tire pressure warning light circuit
Click here
TC and CG terminal circuit
Click here
- If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
- If the tire pressure warning light does not indicate any DTCs or the normal system code, inspect the tire pressure warning light circuit or TC and CG terminal circuit.
Text in Illustration *1
DLC3
*2
Tire Pressure Warning Light
*a
Normal System Code
*b
ON
*c
OFF
*d
0.25 sec.
*e
Code 13 and 33
*f
0.5 sec.
*g
2.5 sec.
*h
1.5 sec.
*i
4.5 sec.
*j
Repeat
Refer to the Diagnostic Trouble Code Chart (Click here) for DTC information.
After completing the check, turn the ignition switch off and remove SST from the DLC3.
| CLEAR DTC |
- HINT:
- After repairing the malfunctions, clear the DTCs.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch ON.
Turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear DTCs following the prompts on the GTS screen.
- HINT:
- Refer to the GTS operator's manual for further details.

