HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the push-button start function.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the push-button start function.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- The following 5 items are important points in the problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Running conditions, driving conditions, weather conditions
How did it happen?
Problem symptoms
| |||||
| 3.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Result Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
for LHD with Entry and Start System
B
for RHD with Entry and Start System
C
|
|||||
|
|||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs.
Result Result
Proceed to
DTC is not output again
A
DTC is output again
B
|
|||||
| |||||
| 6.INSPECT BASIC OPERATION |
- *1: for Automatic Transaxle
- *2: for Manual Transaxle
Check that the engine can be started by the basic operation.
Push the engine switch when the brake pedal*1 or clutch pedal*2 is depressed and the shift lever is in P*1. Check that the engine starts.
- OK:
- Engine starts.
Check that the engine switch mode can be changed by pushing the engine switch.
Without depressing the brake pedal*1 or clutch pedal*2, push the engine switch repeatedly. Check that the power source mode turns from off to on (ACC) to on (IG) and back to off.
- OK:
- Power source mode changes as described above.
With the brake pedal*1 or clutch pedal*2 depressed and the shift lever in P*1, push the engine switch. Check that the engine starts normally from any power source mode status.
- OK:
- Engine starts normally from any power source mode status.
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in the problem symptoms table
A
Fault is listed in the problem symptoms table
B
|
|||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here).
Data List/Active Test (Click here).
| |||||
| 9.REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
| |||||