2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Parking Brake Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E250925E10

INSPECTION PROCEDURE

HINT:
When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contract setting for Connected Services (w/ Connected Services Function).


1. CHECK VEHICLE SIGNAL (OPERATION CHECK)

  1. E225776E02
    Display the "Vehicle Signal Check Mode" screen (Click here).

  1. Check that the display changes between ON and OFF according to the parking brake operation.

    OK:
    Parking Brake Position
    Display
    Applied
    ON
    Released
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
  1. Disconnect the G77 parking brake switch assembly connector.

  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-15 (PKB) - G77-1
    Always
    Below 1 Ω
    H51-15 (PKB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the parking brake switch assembly (Click here).

  1. Inspect the parking brake switch assembly (Click here).



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY (Click here)
OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)


← Parking Brake Switch Circuit (Aug 2013 – Jul 2014)Speaker Circuit (Aug 2013 – Jul 2014) →