Steering Pad Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit sends an operation signal from the steering pad switch assembly to the navigation receiver assembly.If there is an open in the circuit, the navigation system cannot be operated using the steering pad switch assembly.
If there is a short in the circuit, the same condition as when a switch is continuously depressed occurs.
Therefore, the navigation receiver assembly cannot be operated using the steering pad switch assembly, and also the navigation receiver assembly itself cannot function.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).
| 1. INSPECT STEERING PAD SWITCH ASSEMBLY |
Remove the steering pad switch assembly (Click here).
Inspect the steering pad switch assembly (Click here).
|
|
||||
| OK | |
| 2. INSPECT SPIRAL CABLE SUB-ASSEMBLY |
Remove the spiral cable sub-assembly (Click here).
Inspect the spiral cable sub-assembly (Click here).
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - SPIRAL CABLE SUB-ASSEMBLY) |
Disconnect the H61 navigation receiver assembly connector.
Disconnect the G40 spiral cable sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance::
Tester Connection
Condition
Specified Condition
H61-21 (SW1) - G40-6 (AU1)
Always
Below 1 Ω
H61-22 (SW2) - G40-5 (AU2)
Always
Below 1 Ω
H61-23 (SWG) - G40-4 (EAU)
Always
Below 1 Ω
H61-21 (SW1) - Body ground
Always
10 kΩ or higher
H61-22 (SW2) - Body ground
Always
10 kΩ or higher
H61-23 (SWG) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
