2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the engine oil and oil filter element (Click here).


CHECK ENGINE OIL LEVEL
  1. Warm up the engine and then wait for 5 minutes after turning the engine off. The oil level should be between the low level and full level marks of the dipstick.

    1. If low, check for leakage and add oil up to the full level mark.

      NOTICE:
      Do not add engine oil above the full level mark.


INSPECT OIL PRESSURE
  1. Remove the oil pressure switch (Click here).

  1. A227365E01
    Install an oil pressure gauge.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Install the vacuum pump oil inlet hose (Click here).

  1. Install the engine oil level dipstick guide (Click here).

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idling
    29 kPa (0.3 kgf/cm2, 4.3 psi) or higher
    3000 rpm
    294 to 539 kPa (3.0 to 5.5 kgf/cm2, 43 to 78 psi)

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the engine oil level dipstick guide (Click here).

  1. Remove the vacuum pump oil inlet hose (Click here).

  1. Remove the oil pressure gauge.

  1. Install the oil pressure switch (Click here).

← INSTALLATION (from Aug 2014)COMPONENTS (from Aug 2013) →