Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
DTC output mode is set by connecting terminals TC and CG of the DLC3.
WIRING DIAGRAM
HINT:
When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
INSPECTION PROCEDURE
NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).
1. INSPECT DLC3
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (for LHD: Click here, for RHD: Click here).
OK:
CAN Bus Check indicates no malfunctions in CAN communication.
Result
Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)