2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE FAN SHROUD

  1. A218410
    Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the vane pump V belt and the fan and generator V belt (Click here).

  1. A224938
    Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.


INSPECT WATER PUMP ASSEMBLY

HINT:
  1. The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the air hole or the bottom of the engine water pump assembly. Engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces.
  2. Before performing this inspection, check that there is no coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.
  3. Perform this inspection when the engine is cold.

  1. A218415E01
    Visually check the engine water pump assembly.
    Text in Illustration 
    *1
    Air Hole

    1. Check that engine coolant is not dripping from the engine water pump assembly.

      HINT:
      1. If engine coolant is dripping, replace the engine water pump assembly.
      2. If engine coolant is not dripping, perform the following check.

  1. Turn the pulley, and check that the pump bearing moves smoothly and quietly.
    If the bearing moves roughly or noisily, replace the water pump assembly.


INSPECT FLUID COUPLING ASSEMBLY

  1. A224913
    Remove the 4 nuts and fan.

  1. A224917
    Check the fluid coupling for damage or silicon oil leaks. If necessary, replace the fluid coupling.

  1. Install the fan with the 4 nuts.

    Torque:
    6.5 N*m{ 66 kgf*cm , 58 in.*lbf }


INSTALL FAN SHROUD
  1. Install the fan pulley to the water pump.

  1. Install the shroud together with the coupling fan between the radiator and engine.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Temporarily install the fluid coupling fan to the fan pulley with the 4 nuts. Tighten the nuts as much as possible by hand.

  1. A224939
    Attach the claws of the shroud as shown in the illustration.

  1. Install the shroud with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Install the fan and generator V belt and vane pump V belt (Click here).

  1. Tighten the 4 nuts of the fluid coupling fan.

    Torque:
    19 N*m{ 189 kgf*cm , 14 ft.*lbf }

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →