C1751/51 Compressor Relay Coil Malfunction
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
When the "up" side of the height control switch is pressed, a signal is sent from terminal RC of the suspension control ECU to the AIR SUS relay to turn the relay on.As a result, the current flows to the AIR SUS relay coil, closing the relay contact, and then battery positive voltage is applied to the height control compressor, which causes compressed air to raise the vehicle height.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1751/51 |
Either condition is met:
|
|
- HINT:
- Once the suspension control ECU stores DTC C1751/51 in memory, vehicle height control is suspended until a normal signal is input to the suspension control ECU from the AIR SUS relay. However, control is resumed if the ignition switch is turned off and then to ON again.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the suspension control ECU, perform registration (Click here).
- HINT:
- If DTC C1782/82 is output at the same time as C1751/51, perform the inspection necessary for DTC C1782/82 first (Click here).
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (COMPRESSOR MOTOR RELAY) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / Air suspension / Active Test.
Air Suspension Tester Display
Test Part
Control Range
Diagnostic Note
Compressor Motor Relay
AIR SUS relay
ON or OFF
- The operating sound of the motor can be heard.
- When the Active Test is performed, Motor Relay in the Data List changes between ON and OFF accordingly.
- OK:
- Operation of motor can be heard.
Result Result
Proceed to
NG
A
OK (When troubleshooting according to problem symptoms table)
B
OK (When troubleshooting according to DTC chart)
C
- The operating sound of the motor can be heard.
|
|
||||
|
|
||||
| A | |
| 2. INSPECT SUSPENSION CONTROL RELAY (AIR SUS) |
Turn the ignition switch off.
Remove the AIR SUS relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 5
12 V battery voltage is not applied to terminal 1 and 2
10 kΩ or higher
12 V battery voltage is applied to terminal 1 and 2
Below 1 Ω
Text in Illustration *1
AIR SUS Relay
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - AIR SUS RELAY) |
Disconnect the R19 suspension control ECU connector.
Remove the AIR SUS relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
R19-22 (RC) - Engine room relay block AIR SUS relay terminal 1
Always
Below 1 Ω
R19-22 (RC) - Body ground
Always
10 kΩ or higher
Engine room relay block AIR SUS relay terminal 2 - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
