INSTALLATION
Removal / installation · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL TRANSFER ASSEMBLY |
for 1KD-FTV:
Install the transfer assembly with the 8 bolts and 2 brackets.- Torque:
- 24 N*m{ 245 kgf*cm , 18 ft.*lbf }
- NOTICE:
- Take care not to damage the adaptor rear oil seal with the transfer input gear spline.
except 1KD-FTV:
Install the transfer assembly with the 8 bolts and bracket.- Torque:
- 24 N*m{ 245 kgf*cm , 18 ft.*lbf }
- NOTICE:
- Take care not to damage the adaptor rear oil seal with the transfer input gear spline.
| 2. INSTALL AUTOMATIC TRANSMISSION WITH TRANSFER |
for A343F:
Install the automatic transmission with transfer (Click here).
for 1GR-FE, A750F:
Install the automatic transmission with transfer (Click here).
for 1KD-FTV, A750F:
Install the automatic transmission with transfer (Click here).
| 3. INSTALL MANUAL TRANSMISSION WITH TRANSFER |
for G52F:
Install the manual transmission with transfer (Click here).
for R150F:
Install the manual transmission with transfer (Click here).
for 1GR-FE, RA61F:
Install the manual transmission with transfer (Click here).
for 1KD-FTV, RA61F:
Install the manual transmission with transfer (Click here).
| 4. ADD TRANSFER OIL |
Remove the filler plug and gasket.
Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
- NOTICE:
- Add oil slowly.
- Add oil a little at a time, waiting several minutes between each addition of oil.
- Add oil slowly.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket to the filler plug and then tighten the plug.
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
| 5. CHECK FOR TRANSFER OIL LEAK |
