2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Intrusion Sensor Cancel Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

  1. When the intrusion sensor OFF switch on the map light assembly is pressed, the sensor off signal is sent to the main body ECU which causes the theft warning radar sensor (intrusion sensor) to stop operating.

WIRING DIAGRAM

B246189E01

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR OFF SWITCH)
  1. Using the intelligent tester, read the Data List (Click here).

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Intrusion Sens OFF SW
    Intrusion sensor OFF switch /
    ON or OFF
    ON: Intrusion sensor OFF switch pushed
    OFF: Intrusion sensor OFF switch not pushed
    -

    OK:
    ON (intrusion sensor OFF switch pushed) and OFF (intrusion sensor OFF switch not pushed) appear on screen according to switch condition.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH)

  1. E140936E19
    Remove the map light (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (GND3) - 26 (SOFF)
    Intrusion sensor OFF switch pushed
    Below 1 Ω
    5 (GND3) - 26 (SOFF)
    Intrusion sensor OFF switch not pushed
    10 kΩ or higher



NG
REPLACE MAP LIGHT ASSEMBLY (INTRUSION SENSOR OFF SWITCH) (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (MAP LIGHT - MAIN BODY ECU AND BODY GROUND)
  1. Disconnect the W7 light connector.

  1. Disconnect the G64 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    W7-26 (SOFF) - G64-23 (SSW1)
    Always
    Below 1 Ω
    W7-26 (SOFF) or G64-23 (SSW1) - Body ground
    Always
    10 kΩ or higher
    W7-5 (GND3) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)


← Intrusion Sensor Cancel Switch Circuit (Aug 2013 – Jul 2014)Theft Warning Siren Circuit (Aug 2013 – Jul 2014) →