Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014from Aug 2014
DESCRIPTION
The theft warning siren assembly (self power siren) has an internal battery. If the vehicle battery cable is disconnected or any of the communication lines are open, the theft warning siren assembly (self power siren) detects this and sounds its siren.
Although the theft warning siren assembly (self power siren) usually sounds by receiving a signal from the main body ECU, the theft warning siren assembly (self power siren) can sound by its internal battery in case the vehicle battery cable is disconnected.
The main body ECU sends an arming signal to the theft warning siren assembly (self power siren) while switching to the armed state, and it sends a disarming signal to the siren while switching to the disarmed state. Also, the main body ECU can cause the theft warning siren assembly (self power siren) to sound by sending an alarm signal during the alarm sounding state.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (THEFT WARNING SIREN)
Operate the intelligent tester according to the steps on the display and select Active Test (Click here).