2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
  1. for 3 Door:
    (Click here)

  1. for 5 Door:
    (Click here)


3. REMOVE REAR ACCELERATION SENSOR

  1. C213603
    Disconnect the connector.

  1. Remove the bolt and rear acceleration sensor.

    NOTICE:
    Replace the rear acceleration sensor with a new one if it is dropped.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →