B1442/42 Air Inlet Damper Control Servo Motor Circuit
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The recirculation damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the air inlet damper to any position, which controls the intake air settings (fresh, fresh/recirculation and recirculation).- HINT:
- Confirm that no mechanical problem is present because this trouble code may be stored when either a damper link or damper is mechanically locked.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1442/42 |
The air inlet damper position does not change when the air conditioning amplifier assembly operates the recirculation damper servo sub-assembly. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
Result Result
Proceed to
DTC B1442/42 is not output
A
DTC B1442/42/ is output
B
DTC B1442/42 and B1497/97 are output
C
|
|
||||
|
|
||||
| A | ||
| ||
| 2. READ VALUE USING INTELLIGENT TESTER (RECIRCULATION DAMPER SERVO) |
Use the Data List to check if the recirculation damper servo sub-assembly is functioning properly (Click here).
Air Conditioner Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Air Inlet Damper Targ Pulse
Recirculation damper servo sub-assembly target pulse / Min.: 0, Max.: 255
7 (pulse): Recirculation
28 (pulse): Fresh
-
Air Inlet Damper Actual Pulse
Recirculation damper servo sub-assembly actual pulse / Min.: 0, Max.: 255
7 (pulse): Recirculation
28 (pulse): Fresh
-
- OK:
- The display is as specified in the normal condition column.
Result Result
Proceed to
OK (When troubleshooting according to the DTC)
A
OK (When troubleshooting according to Problem Symptoms Table
B
Both target pulse and actual pulse do not display
C
Target pulse displays normally, but actual pulse does not display
D
|
|
||||
|
|
||||
|
|
||||
| A | |
| 3. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1442 is not output.
|
|
||||
| OK | ||
| ||
| 4. CHECK RECIRCULATION DAMPER SERVO SUB-ASSEMBLY |
Replace the recirculation damper servo sub-assembly (Click here).
- HINT:
- Since the recirculation damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the recirculation damper servo sub-assembly with a new or normally functioning one.
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1442 is not output.
|
|
||||
| OK | ||
| ||
| 5. CHECK AIR CONDITIONING HARNESS ASSEMBLY |
Temporarily replace the air conditioning harness assembly with a new or normally functioning one (Click here).
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC B1442 is not output.
|
|
||||
| OK | ||
| ||
