2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Microphone Circuit between Microphone and Radio Receiver

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Using this circuit, the radio and display receiver assembly sends power to the telephone microphone assembly, and the telephone microphone assembly sends microphone signals to the radio and display receiver assembly.

WIRING DIAGRAM

E286161E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - MAP LIGHT ASSEMBLY)
  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Disconnect the W7 map light assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-6 (SNS2) - W7-14 (SNS2)
    Always
    Below 1 Ω
    H51-4 (MACC) - W7-11 (MACC)
    Always
    Below 1 Ω
    H51-5 (MIN+) - W7-12 (MCO+)
    Always
    Below 1 Ω
    H51-19 (MIN-) - W7-13 (MCO-)
    Always
    Below 1 Ω
    H51-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    H51-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    H51-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    H51-18 (SGND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY

  1. E280108E14
    Remove the radio and display receiver assembly with its connectors still connected (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    H51-4 (MACC) - Body ground
    Ignition switch ACC
    4 to 6 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H51-18 (SGND) - Body ground
    Always
    Below 1 Ω
    H51-19 (MIN-) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Component with harness connected
(Radio and Display Receiver Assembly)


NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE MAP LIGHT ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)


← Reverse Signal Circuit (from Aug 2014)Microphone Circuit between Microphone and Radio Receiver (from Aug 2014) →