Back Door Courtesy Switch Circuit
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The main body ECU receives a door open/closed signal from each door courtesy light switch.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (DOOR COURTESY LIGHT SWITCH) |
Using the intelligent tester, read the Data List (Click here).
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Courtesy SW
Back door courtesy switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
Glass Hatch Courtesy Switch*
Glass hatch courtesy switch signal / ON or OFF
ON: Glass hatch open
OFF: Glass hatch closed
-
- *: w/ Glass Hatch Opener System
- OK:
- The display is as specified in the normal condition column.
Result Result
Proceed to
OK
A
NG (Back door courtesy light switch does not operate)
B
NG (Glass hatch courtesy light switch does not operate)
C
- *: w/ Glass Hatch Opener System
|
|
||||
|
|
||||
| A | ||
| ||
| 2. INSPECT BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY |
Remove the back door courtesy light switch (Click here).

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
1 - Switch body
Pin not pushed
Below 1 Ω
Pin pushed
10 kΩ or higher
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR COURTESY LIGHT SWITCH ASSEMBLY) |
Disconnect the G64 main body ECU connector.
Disconnect the R9 back door courtesy light switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G64-19 (BCTY) - R9-1
Always
Below 1 Ω
G64-19 (BCTY) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
| 4. INSPECT BACK WINDOW LOCK ASSEMBLY (GLASS HATCH COURTESY LIGHT SWITCH) |
Remove the back window lock (Click here).


Text in Illustration 

Open
-
-
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (-) - 2 (+)
Open
Below 1 Ω
Closed
10 kΩ or higher
|
|
||||
| OK | |
| 5. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK WINDOW LOCK ASSEMBLY AND BODY GROUND) |
Disconnect the G64 main body ECU connector.
Disconnect the X4 back window lock connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G64-1 (GCTY) - X4-2 (+)
Always
Below 1 Ω
G64-1 (GCTY) - Body ground
Always
10 kΩ or higher
X4-1 (-) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
