2013-2015 Land Cruiser Prado · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.

NOTICE:
Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


1. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.


2. REMOVE AIR CLEANER CASE (for 2TR-FE RHD)
  1. Remove the air cleaner case (Click here).


3. REMOVE AIR CLEANER CASE ASSEMBLY (for 5L-E RHD)
  1. Remove the air cleaner case assembly (Click here).


4. REMOVE CLUTCH TUBE (for Manual Transmission)

  1. C215285
    Slide the clip and disconnect the clutch tube.


5. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
  1. Remove the brake master cylinder sub-assembly (Click here).


6. REMOVE BRAKE PEDAL RETURN SPRING

7. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin from the brake pedal.


8. DISCONNECT BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Loosen the brake master cylinder push rod clevis lock nut.

  1. Disconnect the push rod clevis.


9. DISCONNECT VACUUM HOSE

  1. C215264E01
    Slide the clip and disconnect the vacuum hose.
    Text in Illustration 
    *A
    for LHD
    *B
    for RHD


10. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY
  1. Remove the vacuum check valve assembly from the brake booster assembly.


11. REMOVE CHECK VALVE GROMMET
  1. Remove the check valve grommet from the brake booster assembly.


12. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY (for RHD)
  1. Remove the clutch master cylinder assembly (Click here).


13. DISCONNECT BRAKE TUBE CLAMP (for RHD)

  1. C215284
    Remove the brake tube from the 2 brake tube clamps.

  1. Disconnect the 2 brake tube clamps from the body.


14. REMOVE BRAKE BOOSTER ASSEMBLY

  1. C214646
    Remove the 4 nuts and brake booster assembly from the body.

    NOTICE:
    Do not damage the brake lines.


15. REMOVE BRAKE BOOSTER GASKET
  1. Remove the brake booster gasket from the brake booster assembly.


16. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS
  1. Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.

← ON-VEHICLE INSPECTION (from Aug 2013)REMOVAL (from Aug 2014) →