B279A Theft Deterrent System Communication Line High Fixation
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck on HI output, the ECM stores this DTC.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B279A |
The communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck on HI output for 6 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the transponder key ECU assembly and/or ECM, refer to the Service Bulletin.
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the transponder key ECU assembly and/or ECM, refer to the Service Bulletin.
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Check for DTCs (Click here).
Result Result
Proceed to
DTC B279A is output
A
DTC B279A and other DTCs are output
B
- HINT:
- If any DTCs other than B279A are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 3. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
Disconnect the G74 ECU connector.
Disconnect the G60*1, G56*2 or G58*3 ECM connector.
- *1: for 2TR-FE
- *2: for 1GR-FE
- *3: for 1KD-FTV
- *1: for 2TR-FE
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for 2TR-FE Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - G60-31 (IMI)
Always
Below 1 Ω
G74-13 (EFIO) or G60-31 (IMI) - Body ground
Always
10 kΩ or higher
for 1GR-FE Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - G56-14 (IMI)
Always
Below 1 Ω
G74-13 (EFIO) or G56-14 (IMI) - Body ground
Always
10 kΩ or higher
for 1KD-FTV Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - G58-28 (IMI)
Always
Below 1 Ω
G74-13 (EFIO) or G58-28 (IMI) - Body ground
Always
10 kΩ or higher
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
for 2TR-FE Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - Body ground
Always
Below 1 V
G60-31 (IMI) - Body ground
for 1GR-FE Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - Body ground
Always
Below 1 V
G56-14 (IMI) - Body ground
for 1KD-FTV Tester Connection
Condition
Specified Condition
G74-13 (EFIO) - Body ground
Always
Below 1 V
G58-28 (IMI) - Body ground
|
|
||||
| OK | |
| 4. CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT) |
Using an oscilloscope, check the waveform.


Text in Illustration *A
for 2TR-FE
*B
for 1GR-FE
*C
for 1KD-FTV
-
-
*a
Component with harness connected
(ECM)
*b
Waveform
Measurement Condition Item
Content
Tester Connection
G60-31 (IMI) - Body ground*1
G56-14 (IMI) - Body ground*2
G58-28 (IMI) - Body ground*3
Tool Setting
10 V/DIV., 100 ms./DIV.
Condition
Ignition switch ON
- *1: for 2TR-FE
- *2: for 1GR-FE
- *3: for 1KD-FTV
- OK:
- Waveform is output normally (refer to illustration).
- *1: for 2TR-FE
|
|
||||
| OK | ||
| ||
| 5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
Disconnect the G74 ECU connector.

Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
G74-1 (+B) - Body ground
Always
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G74-16 (GND) - Body ground
Always
Below 1 Ω
| *a |
Front view of wire harness connector (to Transponder Key ECU Assembly) |
|
|
||||
| OK | |
| 6. REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly (Refer to the Service Bulletin).
| NEXT | |
| 7. REGISTER ECU - ECM COMMUNICATION ID |
Register the ECU - ECM communication ID (Refer to the Service Bulletin).
| NEXT | |
| 8. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 9. CHECK FOR DTC |
Check for DTCs (Click here).
- OK:
- DTC B279A is not output.
Result Result
Proceed to
OK
A
NG (for 2TR-FE)
B
NG (for 1GR-FE)
C
NG (for 1KD-FTV)
D
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
